Как поменять датчик высоты
Добавлено: 24 сен 2014, 16:27
Как поменять датчик высоты на задней пневмо подвески, и где она находится. Lincoln Continental 1989 года
Форум любителей американских автомобилей
https://amavto.ru/forum/
http://www.lincolnvscadillac.com/tech/l ... ension.pdfHEIGHT SENSOR
Removal (Front & Rear)
1) Turn suspension switch to "OFF" position. See Fig. 2.
Disconnect electrical connector located in engine compartment behind
shock tower. Push connector through access hole in shock tower.
2) For rear sensor, electrical connector is located in the
luggage compartment in front of forward trim panel. Pull luggage
compartment carpet back for access to sensor sealing grommet located
on floor pan.
3) Raise vehicle as previously outlined until suspension is
at full rebound. Disconnect bottom and then top end of sensor from
attaching studs. Disconnect sensor wiring harness from plastic clips
on shock tower and remove sensor.
4) For rear sensor, push upward on sealing grommet to unseat
sensor. Push sensor through floor pan hole into luggage compartment.
Installation
To install, reverse removal procedure. Turn air suspension
switch to "ON" position after installation.